High Performance Convenional 2 Wire Smoke Detector For Fire Alarm Fire Security

Product Specification

Introduction
 

By quickly and reliably detecting the presence of smoke and activating an alarm, conventional smoke detectors play a critical role in fire safety, providing early warning of potential fires and allowing building occupants to evacuate the premises in a timely manner.

The primary function of a conventional smoke detector is to detect the presence of smoke, which is an early indicator of a fire, and to activate an alarm to alert building occupants of the potential fire hazard.

Here are the key functions of a conventional smoke detector:

Smoke Detection:
Conventional smoke detectors use either ionization or photoelectric (optical) smoke detection technology to sense the presence of smoke particles in the air.
The detector's sensor continuously monitors the surrounding environment for changes in the concentration of smoke particles.
When the smoke density reaches a pre-determined threshold, the detector recognizes the presence of smoke.

Alarm Activation:
Upon detecting smoke, the conventional smoke detector will activate an alarm to notify building occupants of the potential fire emergency.
The alarm can take the form of an audible signal, such as a buzzer or siren, and/or a visual signal, such as a flashing light.
The alarm is designed to be loud and attention-grabbing to ensure that occupants are aware of the need to evacuate the building.

Monitoring and Reporting:
Some conventional smoke detectors may be connected to a centralized fire alarm control panel or system.
This allows the status of the smoke detector, including any alarm conditions, to be monitored and reported to a central location, such as a fire station or security office.

Self-Monitoring and Testing:
Many conventional smoke detectors incorporate self-monitoring and testing capabilities to ensure they remain in good working order.
This may include periodic self-checks of the sensor, power supply, and internal components, as well as the ability to perform manual testing by the building occupants or maintenance personnel.

Parameters

IMPORTANT: The detector must be tested and maintained regularly following NFPA 72 requirements. The detector should be cleaned at least once a year.
INSTALLATION
NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.
NOTE: Verify that all detector bases are installed, that the initiating-device circuits have been tested, and that the wiring is correct.
Remove power from initiating-device circuits before installing detectors.
1. Wire the sensor base per the wiring diagram, Figure 1.
2. Install the sensor into the sensor base. Push the sensor into the base while turning it clockwise to secure it in place.
3. After all sensors have been installed, apply power to the control unit.
4. Test the sensor(s) as described in the TESTING section of this manual.
5. Notify the proper authorities that the system is in operation.

      Warning:Forbid connect 24VDC directly without current-limiting resistance. Otherwise, the detector would be burnt out.

Product range

Conventional Fire Alarm System
Addressable fire alarm system
Gas Extinguishing control system
Beam Detector
4 wire smoke detectors with relay output.
2 wire Conventional smoke and heat detectors
Explosion-proof flame detector for fire alarm system
Standalone smoke detectors and combustable gas detector

Service

1. OEM &ODM service.
2. Provide technical support and after-sale service.
3. 1 year warranty.
4. Normally 15 working days lead time.
5. Welcome sample order.