Blue Color Lamella Plate Settler / PVC Inclined Tube For Settling Tank

Product Specification

Blue Lamella Plate Settler / PVC inclined tube For Settling Tank

Inclined pipe is mainly used for sedimentation and desanding. It is the most widely used and mature water treatment device in water supply and drainage engineering in more than ten years. It has the advantages of wide application range, high treatment effect and small floor area. It is suitable for desanding at water inlet, settling, oil separation and tailings concentration treatment of general industrial and domestic water supply. It is suitable for both new construction and reconstruction of existing old pool, and can achieve good economic benefits

Our PVC tube settler is fully automated production. Compared with manual cutting or machine pressing, Our PVC inclined pipe has uniform thickness,our size is more accurate,shape is more regular and the appearance is more beautiful.

We avoid situations where the edges are not straight, have burrs and are irregular in shape, due to manual cutting. In addition, our tube settler has clear edges and corners.However, when the tube settler needs to reach a certain thickness, the angle of the tube settler produced by the traditional tube settler machine will be arc-shaped.

It also avoids the non-standard size caused by machine pressing.The length and width of a 1-meter tube settler made by Machine pressing, the actual length is only 96 cm,the size deviation is large.The thickness of the tube settler by the machine pressing is uneven and easy to break.

Technology Parameter    

Installation procedure     

1. Installation of sludge discharge pipe at the bottom of inclined pipe sedimentation tank the installation sequence of inclined pipe sedimentation tank generally starts from the bottom, and the installation of sludge discharge pipe system at the bottom is completed first to ensure that the opening of sludge discharge pipe meets the design requirements, is fixed firmly, and is not allowed to enter the next installation sequence until it is checked to be correct. A kind of

2. Complete the packing support installation of inclined pipe according to the packing support installation construction drawing of inclined pipe sedimentation tank, first install the packing support in place, check that all welding joints are firm, the support strength is enough to bear the packing weight, and complete the anti-corrosion treatment on the support surface;

3. Complete the hot joining of inclined pipe packing according to the hot joining method of inclined pipe packing, each packing of inclined pipe packing shall be treated as a separate hot joining unit, which is 1m2 after the hot joining of one unit. After the hot joining, it shall be stacked orderly on the site (a small amount of loose pieces shall be reserved for standby). A kind of

4. Assembly in inclined tube packing tank assemble the pressed packing unit on the upper part of the packing support from left to right. Keep the angle of 60 ° unchanged all the time. Each unit shall be properly pressed during assembly in sequence. If the size is not right when assembling to the right side, it is necessary to use a piece of oblique tube packing according to the size to iron and connect until all are in place.

5. The upper part of the inclined pipe packing is fixed because the proportion of the inclined pipe packing is 0.92, which is slightly less than water, the inclined pipe packing needs to be pulled from left to right above the packing after it is assembled in the tank The round steel of 10 mm shall be reinforced (two round steels are required to pass the upper part of each unit filler). Both ends of the round steel shall be reliably fixed on the wall of the sedimentation tank. After the installation of the round steel, it can well prevent the possible loosening and floating of the inclined pipe filler in the initial use. The round steel shall be corrosion-resistant with coal tar epoxy asphalt.