High Flux High Power Cob LED 50W LM80 HF4027JP15H ANSI SDCM

Product Specification

High Flux High Power Cob LED 50W LM80 HF4027JP15H ANSI SDCM

• Efficacy of 130 lm/W typical for 3000K, 80CRI

• Compact high flux density light source

• Uniform, high quality illumination

• High voltage or Low voltage DC operation

• Product series and company logo on the front

• RoHS compliant

- LED lights are characterized by low voltage and high brightness. A 10-20 watt LED light source emits light equivalent to a 30-120 watt incandescent lamp. The lighting effect of LED is more than 90% energy-saving than incandescent lamps, and more than 70% energy-saving than energy-saving lamps. It is a real energy-saving light source.
- No damage, no mercury ions or mercury ions may leak and other public hazards during the manufacturing process of the bulb. The manufacture of LED epoxy resin belongs to organic polymer compounds, hydrochloric acid phosphorus solvents and most
- Stable, not easy to be damaged, can be recycled even after aging, will not pollute the environment
- LED uses solid-state semiconductor chips to convert electrical energy into light energy, and is encapsulated with epoxy resin, which can withstand high-strength mechanical shocks.

The part number designation for TYF ML Series LED arrays is explained as follows:

Chip LED Cob Product advantages:

1. Good thermal performance and wide hot channel.

2. The spot is uniform.

3. Energy saving and environmental protection, high light efficiency.

4. High brightness, low light decay, polished.

5. Easy to use and easy to install.

6. Strong antistatic ability.

5.1 Color Binning Information

Figure 1: Graph of Test Bins in xy Color Space (Pulsed Test Conditions, Tj = 25°C)

CIE1931-x

Table 38: 2-Step to 5-step MacAdam ellipse color bin definitions for TYF CoB Core Range

6.1 Table 39: Maximum Ratings

Notes for Table 39:

• Driven the arrays at higher currents however lumen maintenance may be reduced.
• Proper current derating must be observed to maintain junction temperature below the maximum
• Pulsed operation with a peak drive current equal to the stated peak pulsed forward current is acceptable if the pulse on-time is ≤1ms per cycle and the duty cycle is ≤10%
• Light emitting diodes are not designed to be driven in reverse voltage and will not produce light under this condition. Maximum rating provided for reference only.

Notes: 1. All dimension tolerance is ±0.2mm unless otherwise noted. 2. Tc measurement point at cathode

RECOMMENDED SOLDERING CONDITION

For manual soldering. Please use lead-free soldering and the soldering shall be implemented using a soldering bit at a

temperature lower than 350C, and shall be finished within 3.5 seconds for one land. No external force shall be applied

to resin part while soldering is implemented. Next process of soldering should be carried out after the product has

return to ambient temperature. CAUTION: TEMPERATURE CONTROL

Product Packing and Labeling