Product Specification

Construction Site Fence panels as4687-2007 standard 2100mm x 2400mm QLD brisbane OD 32mm x 1.40mm,1300 temp fence

It is consist of welded mesh panel,round tube frame(square tube frame),plastic feet and top connection. This kind of fence has a superior structure, the globality,mobility and environmental suitability is very good .The fence is easy transport , dismantle easily ,low cost . It has the advantage of one cost, many times used.

Material: hot dip galvanized tube and wire
Zinc coating: 200g/m2 on wire,300g/m2 on pipes
Hot Dipped Galvanized : Australian Standard-42 Microns.


Two type of Temporary fence

1. Welded tempoary fence 2. chain link temporary fence

Accessories of temporary fence

1.

The clamp of Temporary Fence
---High quality Temporary Fence Clamps.
---Hot Dipped Galvanized TO Australian Standard-42 Microns.
---Specially moulded and 4 mm thick for additional strength.


2.
Cemented plastic fence feet

---Standard specification:580mm long,245mm wide,130mm high
---Thickness of the block:2.5mm
---Hole diameter:25mm,32mm,42mm & 48mm


Our plastic fence feet offer the following benefits over standard concrete fence feet:
---Made of plastic which is made from polypropylene.
---UV5 for sun/weather protection.
---A piece of high quality steel bar for reinforcement.
---Post holes can run across or go up and down the blocks.
---Designed to be filled with concrete.

 

the fencing brace:

Temporary fence stays are used to support the temporary fence in high wind situations or on long runs to ensure the fence once erected remains secure.
Fence stays are hot dipped galvanised to Australian Standard - 42 Microns and are attached to the mesh panels by 2 clamps and weighted down by concrete filled plastic feet.


Applications of Hot dip galvanized Australia temporary fence

1. commercial construction sites 2. Domestic housing sites

Temporary fence welded quality control

1. Use carbon-dioxide arc welding(CO2gas)
2. Anti -climb mesh infill
3. 360° weld between the vertical & horizontal pipe
4. High zinc coating on pipes 42 microns =300g/m2



Temporary fence produce process

Pre hot dip gal. wire drawing--- cut wire and pipes ---wire welded---cut the corners of the mesh---Pre hot dip gal. pipes welded-polish the welds-paint anti-rust epoxy-spray sliver powder coat on each welds-stacking-packaging

Specification of Temporary Fence

Recommended Specification of temporary fence

Different specifications are available according to customers' special inquiry or detailed drawings.
 

Character of temporary fence

1. It is made by good quality Q195 wire and Q235 pipes with high strength.
2. Treatment is hot dipped galvanized,and 200g/m2 on wires,300g/m2 on pipes.
3.It can last more than 10 years,save your maintenance cost.
4. Easy to relocate & stackable
5.No digging or pavement damage with the plastic concrete feet
6. Quick installations & removal,and it can be taken by one person
7. Guaranteed long-term use without rusting
8. Allow repeated use, rental, or resale
9. Corrosion resistant, age resistant, sunshine proof, weather proof, easy installation and move

Packaging of temporary fence


1>There is rubber mat at the bottom of the pallet to avoid the pallet destroyed the panels
2>There is 4 metal corners to keep the pallet more strong.
3>There is metal plate under the plastic bandage to reduce the apressure of fence panels.
4>There is wooden plate at the top of fence panel which can protect the fence panels from being crushed by other pallets.