Brightest LED Solar Street Lights Integrated And Split IP67 Waterproof

Product Specification

 Integrated And Split Outdoor Courtyard Garden Landscape Wall Light Solar Street Light

1. Solar Street Lights Description 

Solar street lights are powered by crystalline silicon solar batteries, maintenance-free valve-regulated sealed batteries (gel batteries) store electrical energy, ultra-bright LED lamps are used as light sources, and are controlled by intelligent charge and discharge controllers, which are used to replace traditional public power lighting. Street lights.

2. Solar Lawn Lights Details

3. work principle

Solar street lights are a kind of traffic and road status lights that supply energy. Street lights play a very important role in urban life. During the day, it can use the solar circuit board to charge the battery in the street lamp. At night, the battery can supply power to the lamp, which can fully meet the needs of lighting.

4.  Install 

⒈Fix the components of each part: the solar panel is fixed on the solar panel bracket, the lamp holder is fixed to the arm, and then the bracket and the arm are fixed to the main pole, and the connecting wire is passed to the control box (battery box).

⒉Before lifting the lamp pole, first check whether the fasteners of each part are firm, whether the lamp holder is installed correctly, and whether the light source is working normally. Then check whether the system is working normally; loosen the solar panel connection line on the controller, and the light source works.

⒊Pay attention to safety precautions when hoisting the main light pole; the screws are absolutely fastened, if the component's sun-facing angle is deviated, you need to adjust its sun-facing direction to the south completely.

⒋Put the battery into the battery box, and connect the connecting wire to the controller according to the technical requirements; first connect the battery, then the load, and then the solar panel; during the wiring operation, be sure to pay attention to the various wiring and the terminal marked on the controller Wrong connection, the positive and negative polarities cannot collide, and cannot be reversed; otherwise, the controller will be damaged.

⒌Check whether the system is working properly; loosen the solar panel connection line on the controller, the light is on; connect the solar panel connection line, the light is off; at the same time, carefully observe the changes of the indicators on the controller; everything is normal before sealing the control box.

5. Attention  

⒈Solar street lamps use solar radiation as energy source. Whether the sunlight shining on the photovoltaic cell module is sufficient or not directly affects the lighting effect of the lamp. Therefore, when choosing the installation position of the lamp, the solar cell module can illuminate the sun at any time without leaves. And other obstructions.

⒉Be careful not to clamp the wire at the connection of the light pole when threading. The connection of the wire should be firmly connected and wrapped with PVC tape.

⒊During use, in order to ensure the beauty and the battery components can better receive solar radiation, please clean the dust on the battery components once every six months, but do not wash it from the bottom up with water.

6. Advantage 

1) Energy saving: Solar energy is used to provide electricity, which is inexhaustible and inexhaustible.

(2) Environmental protection: no pollution, no noise, and no radiation.(3) Safety: No accidents such as electric shock or fire.

(4) Convenience: Simple installation, no need to wire or "break the belly" to dig the ground, and there is no concern about power outages.

(5) Long life: The product has high technology content, the control system and accessories are international brands, intelligent design, and reliable quality.

(6) High grade: high-tech products, green energy, users attach importance to science and technology, green image improvement, and upgrading of grades.

(7) Low investment: a one-time investment is equivalent to AC power (the AC power investment is the sum of power transformation, power input, control box, cable