IEC 60745-2-5 Circular Saw Closure Durability And Lower Guard Recovery Time Test

Product Specification

IEC 60745-2-5 Circular Saw Closure Durability and Lower Guard Recovery Time Test Equipment

Product Information:

This test device for circular saw switch and lower guard conforms to EN 60745-2-5: 2010 Annex M21.18, Annex M21.18.301, Annex M21.203, Annex M21.301, figure M.301, IEC60745-2-5:2003 Annex BB.20.102, EN 60745-2-5:2010 clause 17.101 and clause 19.102.3.

It is used to test the circular saw switch performance and circular saw lower guard’s durability and recovery time.

Structure and test principle:

This equipment is composed of two parts, the mechanical system and electrical control system.

Mechanical system is the table for circular saw. There are a switch and sample socket on the table, operator can press the switch to turn on or off the load power supply to the test sample; different sizes of circular saws can be placed and fixed on the table; on the table, device for locking the switch of the hand-held circular saw in the “on” position; the blade can extend to the bottom of the table through the middle groove; under the groove, there are a the putter and two position sensors , which can be drive the lower guard of the circular saw to be opened or closed.

The electrical control system consists of the load power supply, PLC, 7 Inch Touch screen and etc.

Can achieve manual operation and automatic operation.

Manual control:

the operator can press the “lower guard open button” under manual operation, then the lower guard gradually manually open, when the putter makes the lower guard to be opened to the maximum open position (corresponding position sensor indicator is lighting), at this time, operator can stop the lower guard opening action; then operator press “circular saw switch ON/OFF” to be ON or OFF, the switch locking device can automatically lock or release the switch of the circular saw. Operator can press the switch button on the table to achieve to supply or not supply load voltage to the test sample.

Automatic operation:

1. Operator can pre-set the interval time of the locking device lock or release the circular saw

switch, the interval time of the load voltage supplied to the test sample, and the opening residence time of the lower guard of the circular saw, after that, operator only press “Start” on touch screen, the above testing for the circular saw switch will be processed automatically.

2. The following is mainly for the circular saw lower guard’s durability and recovery time test : The saw is to be set for a 90°cut and oriented in the horizontal plane. The lower guard is to be cycled from the full closed position to the maximum open position and then released for 50 000 cycles at a rate not less than 10 cycles per minute, the number of times is recorded by the position sensor. The close time of the lower guard is not less than 0.3s, if exceed 0.3s, then the number of a timeout is counted. The close time of the lower guard of the last time is recorded after the equipment runs to the required test times, and the equipment will automatically stop.

Technical Parameters: