RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Product Specification

RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Description of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Silicone MCSIL-E184 is supplied as a two-component 10 to 1 liquid silicone addition cure system. It consists of Part A and Part B. When two components are thoroughly mixed, the mixture cures to a flexible elastomer, which is well suited for the protection of electrical/electronic applications.

Applications of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

excellent electrical property features in resistant to temperature, corrosion, radiation, insulation, waterproof, damp proofing, shock resistance, thermal conducting, inflaming retarding and weather ability, etc. Adhesive and coating for solar power, HID, LCD displayers, circuit board and electronic components, etc.

Features of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Good Flow ability

Room temperature and heat cure

Good dielectric properties

Rapid, versatile cure processing controlled by temperature

High transparency allows easy inspection of components

Typical properties of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Preparing Surfaces

In applications requiring adhesion, priming will be required for many of the silicone encapsulants. For best results, the primer should be applied in a very thin, uniform coating and then wiped off after application. After application, it should be thoroughly cured prior to application of the silicone elastomer.

Processing & Curing

MC Silicone E184 part A and Part B should be thoroughly mixed at a 10:1 ratio , may be poured/dispensed directly into the container in which it is to be cured. Care should be taken to minimize air entrapment. When practical, pouring/dispensing should be done under vacuum, particularly if the component being potted or encapsulated has many small voids. If this technique cannot be used, the unit should be evacuated after the silicone encapsulant has been poured/dispensed. MC silicone encapsulants may be either room temperature (25°C/77°F) or heat cured. Room temperature cure encapsulants may also be heat accelerated for faster cure. Ideal cure conditions for each product are given in the product selection table.

Pot life and curing rate of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

Cure reaction begins with the mixing process. Initially, cure is evidenced by a gradual increase in viscosity, followed by gelation and conversion to a solid elastomer. Pot life is defined as the time required for viscosity to double after base and curing agent are mixed and is highly temperature and application dependent. Please refer to the data table.

Useful Temperature Ranges

For most uses, silicone elastomers should be operational over a temperature range of -45 to 200°C (-49 to 392°F) for long periods of time. However, at both the low and high temperature ends of the spectrum, behavior of the materials and performance in particular applications can become more complex and require additional considerations and should be adequately tested for the particular end-use environment.

Packing and Storage of RTV 2 Transparent Electronic Silicone Potting Compound For LED Lights

• Silicone rubber is shipped as kits that Part A and B liquid components in separate containers. It is available in packing in 20kg or 25kg, 200kg per pail. (1kg, 5kg, 10kg small packaging can be customized)

• Silicone rubber must be tightly sealed in cool and dry place, prevented from sun and rain. Transport by non-dangerous goods.