Customized Dual Band Cell Phone Signal Amplifier LCD Display 3g4g Signal Booster

Product Specification

900 / 2100 Tri Band Cell Phone Signal Boosters with LCD Display

Model. GW-17GDW-NH

How a signal booster works ?

A cell phone booster works by pulling in weak signal, boosting it, and then rebroadcasting it inside your area in need. Most signal boosters are essentially a three-part system: an outside antenna to capture weak cell signal, an amplifier to boost the weak signal, and an inside antenna to rebroadcast the enhanced signal inside your home or car. The outside antenna is the first major component of a cell phone booster. Usually mounted high on the roof or fascia of the house.

Cell Phone Signal Booster Introduction:

Signal Booster GW-17GDW-NH is designed to enhance and improve the quality of three band GSM 900MHz / DCS 1800MHz / WCDMA 2100MHz connection. There’re black and white colors for options. This model is enough to provide reliable coverage of signal in the area of up to 800 m². It is recommended to use in offices, apartments, houses etc.

The model is equipped with an LCD screen in a nice and symmetrical body, which displays the current level of input signal. The information on the LCD screen, greatly simplifies the process of adjusting the gain of the system. The connectors under the screws allow to build device on a wall or other vertical surface.

Cell Phone Signal Booster Specification:

Other Frequencies for options:

Cell Phone Signal Booster Features:

1. Coverage up to 800 m²

2. Manual mode for adjusting the gain by “+” / “-” button

3. Smart mode for adjusting the gain automatically

4. Fluted surface on aluminum shell provides an optimal cooling

5. LCD Screen displays the working status of AGC and ISO, gain and power in time.

Support any cellular devices (voice & data & video)

Cell Phone Signal Booster Instructions:

FAQ:
1. After installing booster signal not be very good, indoor signal coverage very small ?
> Adjust outdoor antenna's location and direction
> Change another high gain outdoor antenna
> Check whether cables are connected well
> Change more powerful repeater

2. Cell phone signal full bar, but communication quality bad ?
> Much closer distance between indoor and outdoor antenna, separate them with a longer distance.

3. After installing booster not only signal be good, but also more bad ?
> Much closer distance between indoor and outdoor antenna, separate them with a longer distance.

4. Working good for long time, suddenly signal bad ?
> Check whether outdoor cable connectors are flooded
> Check whether power light is working normally
> If cables are not flooded and power light is working normally, the booster should has problems and need to be sent back to factory for repair.

Cell Phone Signal Booster Application:

Cell Phone Signal Booster Installation:

The booster is fixed onto the wall through expansion bolts.
A. Drill holes on the targeted place and install expansion bolts.
B. Align the holes with the expansion bolts, place flat washers, spring washers, and nuts in turn, and tighten the nuts to fasten the installing support.
C. Place the booster on and fasten it.
D. Connect cables and power cables to the booster respectively.
E. After installing the booster as described above, power on the booster to check the operation status.

Connection:
A. BTS Port: donor antenna cable is connected with Outdoor Port;
B. MS Port: service whip antenna is connected with Indoor Port;
C. DC IN: connected with Power adaptor.

Our Workshop:

Our Company:

Greetwin Tech is a strong and reliable factory, focusing on the R&D and Manufacturing of Digital ICS Repeater, RF Repeater, Indoor Signal Distribution System, Trunk Amplifier, Band Selective Repeater for more than 10 years.