330mm Width 600W LM 330i Photo Laminating Machine

Product Specification

LM-330i A3 A4 Cold And Hot Mounting Laminator Photo Laminating Machine

Plastic sealing machine, also known as the forming machine, glue machine, laminating machine, is able to make up and down two floors with glue powder coating membrane, the pressure of the encapsulation sealing machine, it is mainly composed of rubber roller, before and after heating temperature control system, driving system, operation panel parts, such as encapsulation can waterproof, prevent change, prevent fade, prevent breakage, anti-fouling, and so on.

Specification

Features (Type: LM 330i):

• Metal case, strong and durable.
• LED display, super plastic film plate.
• Rapid heating, continuous use.
• Thick film thin film passes through uniformly.
• Environmental protection and energy saving, safe and reliable.

Metal fuselage, strong heat dissipation

Metal fuselage, safe and reliable, fire and lightning protection.

The LED display board

Knob temperature control, digital temperature control, temperature accuracy.

Alloy gear

Alloy gear is not easy to wear, durable and reliable.

Four roll design, multi roll rolling

Pure silicone rubber roller, smooth and safe film, 24 hours continuous film.

Plastic seal 250mic thick film

Thick film through uniform, through smooth, no bubbles.

Cold charge and hot charge, film in and film out

Cold loading and hot loading, film entry and film removal, one-key operation, easy to use, suitable for public use.

Foundation non-slip rubber foot

The base is provided with non-slip foot pad, which makes the machine stable.

Suggestions for thickness and temperature of plastic film:

• 200mic--180 ° C
• 170mic--170 ° C
• 150mic--160 ° C
• 125mic--140 ° C
• 100mic--130 ° C
• 80mic--110 ° C
• 70mic--100 ° C
• 60mic--90 ° C
• 50mic--80 ° C
• 40mic--70 ° C

Cold mounting -- no heating state (suitable for cold mounting of film with a thickness of about 0.6mm). The above Suggestions can be adjusted according to requirements.

Prepare:

Insert the plug into the power socket, turn on the power switch, the power indicator light is on (red), and then the motor starts to work normally. Turn on the preheat power and start preheating. The temperature rose rapidly.

Temperature setting:

Set the button to the desired temperature and warm up for about 3 minutes. When the temperature rises to the set temperature, the work light will be turned on and off many times. The temperature tends to stabilize. At this time, plastic sealing can be performed. In the process of work, the constant light will flicker, and there will be repeated light and dark changes. This means that the lights will constantly flicker, changing the lights and shadows repeatedly. Refers to the internal constant temperature system inside the machine. It is normal when the heating stops in the switching heating state.

Application:

This machine is widely used to envelop ID cards, office documents, photos and documentary cards. The cards packaged can resist against water, alteration pollution, improve their strength and appearance and extend their storage life.
 

1. Metal shell
2. Power indicator light
3. Membrane Indicator
4. Heating indicator
5. Switch setting
6. Temperature Regulating Switch
7. Forward and Reverse Switch
8. Paper entrance
9. limit switch

Packing: 

Single package size: 580*145*258mm

Single gross weight: 6.7 kg

Package Type:

The inner packaging is protected with anti-collision bubble paper, sponge and foam. The outer packaging is packed in cartons and then packed in wooden cases.

Port: Guangzhou / Foshan / Shenzhen / Ningbo