DALI Single Output Dimmable LED Driver 0-10V 50W 1400mA For Downlight

Product Specification

DALI 0-10V Downlight Dimmable LED Driver 50W 1400mA For Downlight, Constant Current Single Output Dimming LED Controller

【Product SUMMARY】 

KS50ADP-1400MCP1H-A4 is a 50W 1400mA AC/DC constant current mode output LED driver featuring the multiple levels
selectable by DIP switch and complies with DALI standard protocol IEC 62386. 【KS50ADP-1400MCP1H-A4 】can
be connected to DALI main controller or Touch DIM to a chieve a smooth dimming effect.

【Applications】

Application of Dimable LED Driver:  Downlight, Panel light, Spotlight, Ceililing Light, Decoration Light, Floor light, Flood light.

【Product Features】

·Single channel output, output current level selectable

. Constant current type
·Meet DALI Protocol IEC 62386
·Support Touch-DIM function
·High efficiency up to 82%
·Built-in active PFC function, PF=0.9
·Dimming effect smooth, no flicker
·Protections: Short circuit, over load, Over voltage
 

【Technical Specifications】

【Dimming Function】

1. Press the Push DIM (Touch DIM) switch for 8s or more,the driver can be controlled via Push DIM switch.
2. Short press the Push DIM (Touch DIM) switch (<0.5s) to control the lamp on or off.
3. Long press the Push DIM (Touch DIM) switch (>0.5s) to dim the brightness of light. The dimming direction will change every time after pressing switch.
4. Double-click the Push DIM (Touch DIM) switch (<0.3s), then all lamps connected on the device will be set maximum brightness.
5. The brightness adjustment range is 1%-100%, and the light can be turned off through short pressing when doing the adjustment with long pressing Push DIM (Touch DIM) switch.
6. With the Power off memory function, the power-down state will be recovered when power on again.

【Cautions】

1.This product should be installed by qualified personnel.
2.This product is non waterproof, need to avoid sun and rain.In case of outdoor use, please ensure it is mounted in a water proof enclosure.
3.Good heat dissipation conditions extend product life. Please install the product in a well-ventilated environment.
4.Please make sure LED power supply output voltage, current is used to meet the product requirements.
5.Please ensure that adequate sized cable is used from the controller to the LED lights to carry the current. Please also ensure that the cable is secured tightly in the connector.
6.Due to safety concerns, PVC or rubber cord of 0.75- 1.5mm² is recommended for input and output terminal(s)(excluding signal terminals). Flat power cord is not suitable.Ensure all wire
connections and polarities are correct before applying power to avoid any damages to the LED lights.
7.In case of malfunction, do not repair it yourself.

【Other similiar models】

 Factory Capacibility: 

1. Professional manufacturer:  17 Years experience,  10,000 square meters factory,

                                                 400+ employees,  8 production lines

2. Scientific Management:        ISO9001:2015 Quality Management System Certified, 7S  administration
3. Independent R&D teams :    10+ Engineer teams, innovative and independent R&D ability

4. Advanced equipment:          SMT plant,  wave-soldering machine,  Semi-auto assembling,

                                                 EMC lab, Test Lab, Ageing room etc.