POE-S224G 24 Port IEEE802.3af/at Gigabit 30W POE Switch (400W Internal Power)

Product Specification

POE-S224G

24 Port Gigabit IEEE802.3af/at 30W POE Switch

2 Port Gigabit SFP Slot Uplink

48Gbps Backplane Bandwidth

400W Built-in Power Supply

POE-S224G, 24 Port Channels Gigabit Power Over Ethernet Switch, it comes with 2 port SFP Slot uplink and it's compliance with IEEE802.3af/at, it has 400 watts power supply adapter built-in, with which, there will be maximum 15.4W assigned on each connected Powered Device (PD), which also means PoE-S224 PoE Switch will conform to IEEE802.3at and each port can be assigned max.30W power if lesss than 12 port PoE output is running simultaneously.

All ports support wire-speed forwarding, 2 Gigabit optical interfaces (SFP port) allow high-speed uplink connection. This 24 ways Power Sourcing Equipment (PSE) supplies power for terminal PD that should support IEEE802.3af or IEEE802.3at, which also call PoE-enabled. Otherwise, it should add an external PoE Splitter as an media connector for PoE-disable device to be connected in a PoE system. This is apparently for Analog Camera to connect active PoE Swith.

On the other hand, there is a handshake protocol which always protecting PoE Switches and involved device from damage due to underload, undervoltage or other issue from incorrect installation. So there is no need to to worry about any damage of PoE switch and PoE PD or Non-PoE device. The POE-PSE will automacally cut the power when the terminal PoE PD is disconnected. POE-S224G is highly integrated design, lightweight, easy to operate, suitable for medium or large office. Based on gigabit network technology, it will effectively avoid network traffic congestion with its excellent network adaptability.

Base on its typical 802.3az Green Ethernet standard feature, it can automatically adjust the delivering signal strength according to the different cable length and the actual loading without any negative influence on its performance and efficiency. Finally, it's energy-effieient and environment friendly.

Main Features

1. 24 ports 10/100/1000Mbps PoE output, 2 ports 10/100/1000Mbps SFP slot uplink

2. Conform to IEEE 802.3, IEEE 802.3u, IEEE802.3ab, IEEE802.3x, IEEE802.3af protocol standard 

3. Half/Full-duplex IEEE with 802.3x standard and Half-duplex with Back-Pressure standard Flow control 

4. UTP Port support automatic consultation function,Automatic transmission way and the transmission rate

5. Store-and-forward switch method

6. Max.100 meters transmission distance via dedium cat5, cat5e, cat6 or higher level quality Ethernet cable, 

7. Comply to IEEE802.3af/at, Maximum 30 watts power supply output in a single port 

8. Dynamic LED lights indicate PoE's running state and help troubleshooting

Detailed Specification

Item: 24 Port Power Over Ethernet Switch (30W POE)

Model: POE-S224G

Network Interface

    - 24 Ports 10/100M/1000Mbps RJ45 PoE Power Output

    - 2 Ports SFP Slot Gigabit Uplink

Network Medium

    - 10Base-T: UTP category 3 cable

    - 100Base-TX: UTP category 5 cable 

    - 1000Base-T: UTP category up 5 cable

Protocol Standard

    - IEEE802.3i 10BASE-T

    - IEEE802.3u 100BASE-TX

    - IEEE802.3x Flow Control

    - IEEE802.3af/at Power over Ethernet

    - IEEE 802.3, IEEE802.3ab, IEEE802.3az

Transfer Speed: 100/1000Mbps Full Duplex

Network Interface: 100BASE-T or 1000BASE-TX Ethernet RJ-45 Port

Primary Performance

    - Bandwidth: 48Gbps

    - Network delay (100 - 1000M bps): Max 20 microseconds (64 Byte)

    - Network delay (1000 - 1000M bps) : Max 10 microseconds (64 Byte)

    - MAC Address 8K,  Addressing: 48-bit MAC address

    - Forwarding rate:10Mbps/14880pps; 100Mbps/148800pps; 1000Mbps/1488000pps

Power Supply

    - 400W internal power supply adapter (AC 100~240 V, 50~60 Hz)

    - PoE power output: Amount Power ≤400W, Maximum 30W a single port

PoE Power Pin Assigment: 1/2 "+"; 3/6 "-"

LED Light

    - Status indicator of Power input and PoE output

    - Each Port Link/ACT/Speed, Gigabit Network Port

Environmental Requirements

    - Operating Temperature: 0°C ~ 50°C (32°F~104°F)

    - Storage Temperature: -40°C  ~ 70°C  (-104°F~158°F)

    - Operating Humidity: 10%~90% Non-condensing

    - Storage Humidity: 5%~90% Non-condensing

    - Working Height: up to 10,000 feet (3,000 meters)

    - Storage Altitude: the largest 10,000 feet (3,000 meters)

Safety Approval: CE, FCC, RoHS

Size: 440mm×350mm×43mm;  Weight: 6 kg/piece

Warranty: One year