5000kg/H Groundnut Sheller Carbon Steel Small Peanut Cracking Machine

Product Specification

5000kg/H Peanut Cleaning Peeling Machine Small Peanut Shelling Machine

※CHECKING THE PEANUT SHELLING MACHINE BEFORE USE:

1. Check whether the fasteners are tightened, the rotating parts are flexible, and whether there is lubricant in each bearing. The groundnut shelling machineshould be placed on a solid and stable ground.

2. Check the power, the switch must be in the OFF position.

3. After the motor starts, the rotation direction should be the same as the indicated on the implement. Run the machine for a few minutes and observe if there is any abnormal noise. When the operation is normal, the peanut can be fed evenlyin the shelling machine.

4. Peanut should be fed evenly and in an appropriate amount. It should not contain iron filings, stones and other debris to prevent breaking the peanuts and causing mechanical accidents. When the peanut is covered with a sieve, the discharge outlet switch can be turned on.

5. Peanuts should be at proper moisture condition. If it is too dry, the crushing rate will be high. If it is too wet, it will affect work efficiency. Select the appropriate screen according to the peanut size.

6. When there are more peanut shells in the peanut, you can move the motor downwards to tighten the fan belt and increase the amount of air blow.

7. Operator should away from the groundnut shelling machine while it is working, or else may be injured by belt drive.

8. When stop using the shelling machine and store it, you should cleanthe external dust, dirt, and residual grains. The machine should be covered well and placed in a dry warehouse to avoid direct sunlight and rain. Belt should be removed and stored separately. Clean the bearings with diesel oil and dry them with butter. Transmission parts and the bearing chamber should be protected with sufficient oil.

※Description:

The peanut shelling machine is composed of frame, air fan, rotors, single-phase motor, two sizes screens, feeding hopper, vibration sieving screen, V-belt wheel and transmission V-belt. After the machine started, the peanuts are put into the hopper in a quantitative, uniform and continuous manner. The peanut shells are broken under the constant impacts of the rotor, friction and collision.

Peanut kernels and broken peanut shells pass through a sieve with a certain aperture under the rotating wind pressure and blow of the rotor. Peanut are shelled and pass a large size screen for the first time, light peanut shells are blown away, smaller peanuts are sieved and collected for a second time shelling. Peanut shells and grains are blown by the rotating fan, and the light-weight peanut shells are blown out of the machine. The peanut grains are screened by a shaker to achieve the purpose of selection. Then, the sorting surface goes down, flows into the lifting device through the returning port, and is sent to the rear drum by the air lifting device.

The peeled peanut and shell fall through the rear arc grille, and are selected by the fan again. The specific gravity sorting sieve will further select qualified peanut and make sure all peanut are shelled.

※Application​:

Peanut 

※Composition​:

1. Peanut Shelling Machine

2. Peanut De-stone machine

※Features:

Stable performance & strong durability

High efficiency & minimum split ratio

Easy operation & low maintenance

Peanut sheller increases productivity and saves manpower, it promotes the raw peanut processing from family to industrial scale.

※Technical data: