150A Small Scale Program Telecom Rectifier System With Perfect Battery

Product Specification

150A Small Scale Program Telecom Rectifier System With Perfect Battery Management

Quick Details:

Payment & Shipping Terms:

1. GPE48150 System Configuration

GPE48150 consists of two layers of 1U insert frame. The first layer consists of rectifier module (at least 1 set, up to 2 sets) and 1monitoring module . The second layer frame consists of rectifier module, and can be up to 3 sets. The second layer is optional, depending on the customer. The configuration is optional, as following table:

2. GPE48150 Operating Principle

AC power (single-phase or three-phase) get into the rectifier module through the AC input terminal (L1, L2, L3, N). OUT+, OUT- is DC power system output terminal. User load and the battery access to the power system DC output terminal through the power-down contactor. load power-down contactor is normally closed under situation of no trigger, battery power-down contactor is normally open under situation of no trigger.

In normal conditions, various parameters of rectifier module and power distribution units are controlled by the monitoring module, and work according to the predetermined parameters or user commands. If there is a power failure, at this time system will be powered by battery, with the discharge of the battery, battery terminal voltage begin to decline, when the battery voltage is lower than 46.2V (adjustable), the monitoring module reports DC undervoltage alarm signal, when the battery voltage drops to 45.6V (adjustable), the monitoring module controls the load power-down contactor, turning off the load power supply. When the external power recovery, the system will restore the normal working state of the battery and the load (the above monitoring data is the system default value, the user can re set).

3. GPE48150 Properties

As shown above, DC output is used for connecting with load and battery;

4. Electrical Connection Instruction

Chassis connects with external electric through system interface board. As shown in figure below:

Wiring Terminal Instruction:

AC input port is used for connecting AC input.

5. Application

(1) Small scale program controlled exchangers

(2) Access network

(3) Transmission equipment

(4) Mobile communication

(5) Satellite communication ground station

(6) Microwave communication

6. Features

(1) Adoption of active power factor compensation technology with factor ＞0.99

(2) Wide operating range of AC input voltage: 90～280Vac

(3) Operating temperature range: -25°C～+55°C

(4) Zero current/voltage switching tech with high efficiency ≥88%

(5) Lifecycle of battery prolonged by perfect battery management, including electrical charge/discharge management, battery temperature compensation, battery capacity test, reversal connection proof protection, low voltage protection etc.

(6) Hot-swappable

(7) Input over/under voltage protection

(8) Output over voltage protection

(9) Output over current protection

(10) Output short circuit protection

(11) Auto current sharing, parallel output

(12) Embedded mounting

7. Packing and Shipping

Our Delivery Agent

The goods can be shipped by sea, by air, by courier, by land, by train, etc.

Besides the following delivery agent, we can also look for the delivery agent with the best price in china if you need us to do for you.

8. Our Contact Information

Mobile Phone: 0086-13752765943

Telephone: 0086-0755 66600941

Email: info@estel.com.cn

           lxf.estel@hotmail.com
Skype: fiona.liang10