Led Macro Ring Flash Light For Canon MarkIII Nikon Olympus Pentax SLR Cameras

Product Specification

Main Function

Full innovation LED flash technology.

More approach natural light use high quality LED light

There are eight level brightness adjustment

It is meets the higher photograph needs under the innovation function

Left and right flash function make the object appeared third dimension

Fit for macroshot, Scientific research.medical and personal hobbies of photography

Instructions and Precautions

1.this product match with specified professional camera,forbid the others.

2.Please do not try to detach the any party of the product by yourself and avoid short circuit or burn-out;if find the shell broken and something wrong of flash light,please go to the specified agency get warranty.

3.Do not flash near your eyw.

4.If more than a span time no flash use (more than two weeks),please put all the batteries out,in order to prevent the battery leakage.

5.When replace the battery,the more disposable replacement of a complete set of batteries.

6.The flash isn’t have waterproof and prevent wind function,so please keep the flash is dry.

LED Ring Flash Installation

Attached are equipped with 40.5mm,52mm,55mm,58mm,62mm,67mm,72mm,77mm,eight different adapter ring, and a color temperature ring.

1.According to the diameter of lens to choose and install corresponding adapter ring.

Note:prevent overexert lead to difficult unload the connection of adapter ring and lens

2.Press the annular light lock and place on the lens with adapter ring,loosen lock button,when annular light have locked in the adapter ring already

Note:Slaking flash light after finished installation,prevent not lock completely and broken.

Install Batteries

According to the direction indicated by an arrow sliding<the battery storehouse cover> open it.

Install the battery by an arrow direction of sticker,ensure the battery contacts are correct to wards.

According to the direction indicated by an arrow sliding <the battery storehouse cover> open it.

Note: please use 4 standard specifications AA battery. Do not use cortical breakage of battery. Prevent the occurrence of short circuit.

Installation and unloaded of the flash control body

According to the direction indicated by an arrow rotate<fixed knob> to the highest level.

The flash<hot shoes base> completely pushed into a camera hot shoes.

According to the direction indicated by arrow rotate<fixed knob> to light.

If remove flash,please loosen <fix knob>,the push it out from camera’s hot shoes.

Pay Attention

If the camera’s cabin flash in pop-up state,please shut-off camera cabin flash first,and then install flash product in camera.

The solutions and may occur problem when using

when long exposure or over exposure.The solution is that Check the shuttle, aperture,ISO of set of camera whether too close to the flash limit or exposure compensation,whether surrounded exposure etc.and relevant set is correct.

Photos of the four corners of the dark is caused by the camera be set to wide-angle.the solution is the adjust camera focus to 50cm or outnumber 50cm.

Flash light is not flash:

Battery without electricity,please replace new battery (recommends N1H1 battery)

Anti placed the electrodes of battery ,battery replaced again.

Flash light or metal of the camera have contacted smudgy,install again after use fiber cloth to clean it. If still have unusual,please replace a group of new battery try again use.

Technical Parameters

Flash GN: 15

Effective flash scope: 5cm-1.5m

Color temperature: 6800k

Exposure time: 1/100 seconds

Power supply:4pcs AA batteries

Weight: 205g