Radio Integrated Antenna Aruba Instant Controller IAP325 320 Series MU-MIMO

Product Specification

• ARUBA 320 SERIES WIRELESS ACCESS POINTS
• AP type: Indoor Instant Access Points, dual radio, 802.11n/ac 4x4:4 MU-MIMO Dual Radio
• AP-320 SERIES SPECIFICATIONS
  •  IAP-325
  --5 GHz (1,733 Mbps max rate) and 2.4 GHz (600 Mbps
  max rate) radios, each with 4x4 MIMO support
  and a total of eight integrated omni-directional
  downtilt antennas.
  WI-FI RADIO SPECIFICATIONS
  • AP type: Indoor, dual radio, 5 GHz 802.11ac and 2.4 GHz
  802.11n 4x4 MIMO.
  • Software-configurable dual radio supports 5 GHz (Radio 0)
  and 2.4 GHz (Radio 1).
  • Four spatial stream SU-MIMO for up to 1,733 Mbps
  wireless data rate to a single client device.
  • Three spatial stream MU-MIMO for up to 1,300 Mbps
  wireless data rate to up to three MU-MIMO capable client
  devices simultaneously.
  • Support for up to 256 associated client devices per radio,
  and up to 16 BSSIDs per radio.
  • Supported frequency bands (country-specific
  restrictions apply):
  --2.400 to 2.4835 GHz
  --5.150 to 5.250 GHz
  --5.250 to 5.350 GHz
  --5.470 to 5.725 GHz
  --5.725 to 5.850 GHz
  • Available channels: Dependent on configured
  regulatory domain.
  • Dynamic frequency selection (DFS) optimizes the use of
  available RF spectrum.
  • Supported radio technologies:
  --802.11b: Direct-sequence spread-spectrum (DSSS)
  --802.11a/g/n/ac: Orthogonal frequency-division
  multiplexing (OFDM)
  • Supported modulation types:
  --802.11b: BPSK, QPSK, CCK
  --802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM,
  256-QAM
  • Transmit power: Configurable in increments of 0.5 dBm
  • Maximum (aggregate, conducted total) transmit power
  (limited by local regulatory requirements):
  --2.4 GHz band: +24 dBm (18 dBm per chain)
  --5 GHz band: +24 dBm (18 dBm per chain)
  --Note: conducted transmit power levels exclude antenna
  gain. For total (EIRP) transmit power, add antenna gain
  • Advanced Cellular Coexistence (ACC) minimizes
  interference from cellular networks.
  • Maximum ratio combining (MRC) for improved
  receiver performance.
  • Cyclic delay/shift diversity (CDD/CSD) for improved
  downlink RF performance.
  • Short guard interval for 20-MHz, 40-MHz and
  80-MHz channels.
  • Space-time block coding (STBC) for increased range and
  improved reception.
  • Low-density parity check (LDPC) for high-efficiency error
  correction and increased throughput.
  • Transmit beamforming (TxBF) for increased signal
  reliability and range.
  • Supported data rates (Mbps):
  --802.11b: 1, 2, 5.5, 11
  --802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
  --802.11n: 6.5 to 600 (MCS0 to MCS31)
  --802.11ac: 6.5 to 1,733 (MCS0 to MCS9, NSS = 1 to 4)
  • 802.11n high-throughput (HT) support: HT 20/40
  • 802.11ac very high throughput (VHT) support: VHT 20/40/80
  • 802.11n/ac packet aggregation: A-MPDU, A-MSDU
  WI-FI ANTENNAS
  • AP-324/IAP-324: Four RP-SMA connectors for external
  dual band antennas. Internal loss between radio
  interface and external antenna connectors (due to
  diplexing circuitry): 2.5 dB in 2.4 GHz and 1.5 dB in 5 GHz.
  • AP-325/IAP-325: Eight integrated downtilt omni- directional
  antennas for 4x4 MIMO with peak antenna gain of 4.0dBi
  in 2.4 GHz and 4.7dBi in 5 GHz. Built-in antennas are
  optimized for horizontal ceiling- mounted orientation of the
  AP. The downtilt angle for maximum gain is ~ 30 degrees.
  Combining the patterns of each of the antennas of the
  MIMO radios, the peak gain of the effective per-antenna
  pattern is 2.7dBi in 2.4GHz and 2.9dBi in 5GHz.
  OTHER INTERFACES
  • Two 10/100/1000BASE-T Ethernet network interfaces (RJ-45)
  --Auto-sensing link speed and MDI/MDX
  --Link Aggregation support to achieve platform throughput
  up to 2 Gbps
  --802.3az Energy Efficient Ethernet (EEE)
  --PoE-PD: 48 Vdc (nominal) 802.3af or 802.3at PoE
  • DC power interface, accepts 2.1/5.5-mm center-positive
  circular plug with 9.5-mm length
  • USB 2.0 host interface (Type A connector)
  • Bluetooth Low Energy (BLE) radio
  --Up to 4dBm transmit power (class 2) and -94dBm
  receive sensitivity
  --Integrated antenna, -5dBi gain (30 degrees downtilt)
  --Can be disabled with configuration
  • Visual indicators (tri-color LEDs): For system and radio status
  • Reset button: Factory reset (during device power up)
  • Serial console interface (RJ-45)
  • Kensington security slot
  POWER
  • Maximum (worst-case) power consumption: 20W
  (802.3at PoE), 13.5W (802.3af PoE) or 18.5W (DC)
  --Excludes power consumed by external USB device (and
  internal overhead); this could add up to 6W (POE) or
  5.5W (DC) for 5W/1A USB device
  • Maximum (worst-case) power consumption in idle mode:
  8W (PoE) or 7W (DC)
  • Direct DC source: 12 Vdc nominal, +/- 5%
  • Power over Ethernet (PoE): 48 Vdc (nominal)
  802.3af/802.3at compliant source
  --Unrestricted functionality with 802.3at PoE
  --Power-save mode with reduced functionality from
  802.3af PoE
  >>USB port disabled
  >>Second Ethernet port disabled
  >>2.4 GHz radio in 1x1:1 mode
  • Power sources sold separately
  • When both power sources are available, DC power
  takes priority
  MOUNTING
  • The AP ships with two (black) mounting clips to attach to a
  9/16-inch or 15/16-inch flat T-bar drop-tile ceiling.
  • Several optional mount kits are available to attach the
  AP to a variety of surfaces; see the Ordering Information
  section for details.
  MECHANICAL
  • Dimensions/weight (unit, excluding mount accessories):
  --203mm (W) x 203mm (D) x 57mm (H)
  8.0” (W) x 8.0” (D) x 2.2” (H)
  --950g/34 oz
  • Dimensions/weight (shipping):
  --315mm(W) x 265mm(D) x 100mm (H)
  12.4” (W) x 10.4” (D) x 3.9” (H)
  --1,350g/48 oz
  ENVIRONMENTAL
  • Operating:
  --Temperature: 0° C to +50° C (+32° F to +122° F)
  --Humidity: 5% to 93% non-condensing
  • Storage and transportation:
  --Temperature: -40° C to +70° C (-40° F to +158° F)
  REGULATORY
  • FCC/ISED
  • CE Marked
  • RED Directive 2014/53/EU
  • EMC Directive 2014/30/EU
  • Low Voltage Directive 2014/35/EU
  • UL/IEC/EN 60950
  • EN 60601-1-1 and EN 60601-1-2
  For more country-specific regulatory information and
  approvals, please see your Aruba representative.
  RELIABILITY
  MTBF: 739,935 hrs (84.5yrs) at +25C operating
  temperature (AP-325)
  REGULATORY MODEL NUMBERS
  • AP-324 and IAP-324: APIN0324
  • AP-325 and IAP-325: APIN0325
  CERTIFICATIONS
  • CB Scheme Safety, cTUVus
  • UL2043 plenum rating
  • Wi-Fi Alliance (WFA) certified 802.11a/b/g/n/ac
  • WPA, WPA2 and WPA3 – Enterprise with CNSA option,
  Personal (SAE), Enhanced Open (OWE)
  • Bluetooth SIG interoperability certification
  • Passpoint® (Release 2) with ArubaOS and Instant 8.3+
  WARRANTY
  • Aruba limited lifetime warranty
  MINIMUM OPERATING SYSTEM
  SOFTWARE VERSIONS
  • ArubaOS 6.4.4.0
  320 Series Access Points are not supported on
  650 Series Mobility Controllers.
  • Aruba InstantOS 4.2.2.0

• RF PERFORMANCE TABLE
  	Maximum transmit power (dBm) per transmit chain	Receiver sensitivity (dBm) per receive chain
  802.11b 2.4 GHz
  1Mbps	18.0	-97.0
  11Mbps	18.0	-89.0
  802.11g 2.4 GHz
  6Mbps	18.0	-93.0
  54Mbps	18.0	-75.0
  802.11n HT20 2.4 GHz
  MCS0/8	18.0	-92.0
  MCS/7/15	16.0	-72.0
  802.11n HT40 2.4 GHz
  MCS0/8	18.0	-90.0
  MCS7/15	16.0	-70.0
  802.11a 5 GHz
  6Mbps	18.0	-93.0
  54Mbps	16.5	-75.0
  802.11n HT20 5 GHz
  MCS0/8/16/24	18.0	-92.0
  MCS7/15/23/31	16.0	-72.0
  802.11n HT40 5 GHz
  MCS0/8/16/24	18.0	-89.0
  MCS7/15/23/31	16.0	-69.0
  802.11AC VHT20 5 GHz
  MCS0	18.0	-92.0
  MCS8	14.0	-65.0
  802.11AC VHT40 5 GHz
  MCS0	18.0	-89.0
  MCS9	14.0	-62.0
  802.11AC VHT80 5 GHz
  MCS0	18.0	-86.0
  MCS9	14.0	-59.0

• 

• FAQ

• Q1.What can you buy from us?

        A:Mellanox, Aruba, Rukus, Extreme brand products, including switches, network cards, cables, Access Point, etc.

  Q2.How about the delivery date?

        A:It usually takes 3-5 working days. For specific models, please contact us to check the stock. In the end, the actual                 consultation shall prevail. We will do our best to deliver as soon as possible.

  Q3.What's your warranty terms?

        A: We supply 12 months warranty time.

  Q4.How about the Shipping Method?

        A: We use Fedex/DHL/UPS/TNT and other air shipments,sea shipments are also workable. In one words, we could do any shipments that you wanted.

  Q5.Can I get some samples?

       A:Yes, sample order is available for quality check and market test. You only need to pay the sample cost and express cost.

  Q6.What are your core strengths?

       A:First-hand supply, Original and new products with the favorable price and perfect after-sales service.