310 Series Antenna Instant Aruba IAP 315 (RW) 802.11n AC 2x2:2 4x4:4

Product Specification

• ARUBA 310 SERIES WIRELESS ACCESS POINTS
• AP type: Instant Indoor access points , dual radio, 802.11n/ac 2x2:2/4x4:4 MU-MIMO Dual Radio
• AP-310 SERIES SPECIFICATIONS
  • AP-315 (controller-managed) and IAP-315 (Instant):
  --5GHz 802.11ac 4x4 MIMO (1,733 Mbps max rate)
  and 2.4 GHz 802.11n 2x2 MIMO (300 Mbps max rate)
  radios, with a total of four integrated omni-directional
  downtilt dual-band antennas
  WI-FI RADIO SPECIFICATIONS
  • AP type: Indoor, dual radio, 5 GHz 802.11ac 4x4 MIMO
  and 2.4 GHz 802.11n 2x2 MIMO
  • Software-configurable dual radio supports 5 GHz (Radio 0)
  and 2.4 GHz (Radio 1)
  • 5 GHz: Four spatial stream Single User (SU) MIMO for up
  to 1,733 Mbps wireless data rate to individual 4x4 VHT80
  or 2x2 VHT160 client devices
  • 2.4 GHz: Two spatial stream Single User (SU) MIMO for
  up to 300 Mbps wireless data rate to individual 2x2 HT40
  client devices
  • 5 GHz: Four spatial stream Multi User (MU) MIMO for up
  to 1,733 Mbps wireless data rate to up to three MU-MIMO
  capable client devices simultaneously
  • Support for up to 256 associated client devices per radio,
  and up to 16 BSSIDs per radio
  • Supported frequency bands (country-specific
  restrictions apply):
  --2.400 to 2.4835 GHz
  --5.150 to 5.250 GHz
  --5.250 to 5.350 GHz
  --5.470 to 5.725 GHz
  --5.725 to 5.850 GHz
  • Available channels: Dependent on configured
  regulatory domain.
  • Dynamic frequency selection (DFS) optimizes the use of
  available RF spectrum.
  • Supported radio technologies:
  --802.11b: Direct-sequence spread-spectrum (DSSS)
  --802.11a/g/n/ac: Orthogonal frequency-division
  multiplexing (OFDM)
  • Supported modulation types:
  --802.11b: BPSK, QPSK, CCK
  --802.11a/g/n/ac: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM
  • Transmit power: Configurable in increments of 0.5 dBm
  • Maximum (conducted) transmit power (limited by local
  regulatory requirements):
  --2.4 GHz band: +18 dBm per chain , +21dBm aggregate (2x2)
  --5 GHz band: +18 dBm per chain , +24dBm aggregate (4x4)
  --Note: conducted transmit power levels exclude antenna
  gain. For total (EIRP) transmit power, add antenna gain
  • Advanced Cellular Coexistence (ACC) minimizes
  interference from cellular networks.
  • Maximum ratio combining (MRC) for improved
  receiver performance.
  • Cyclic delay/shift diversity (CDD/CSD) for improved
  downlink RF performance.
  • Short guard interval for 20-MHz, 40-MHz, 80-MHz and
  160-MHz channels.
  • Space-time block coding (STBC) for increased range and
  improved reception.
  • Low-density parity check (LDPC) for high-efficiency error
  correction and increased throughput.
  • Transmit beam-forming (TxBF) for increased signal
  reliability and range.
  • Supported data rates (Mbps):
  --802.11b: 1, 2, 5.5, 11
  --802.11a/g: 6, 9, 12, 18, 24, 36, 48, 54
  --802.11n (2.4GHz): 6.5 to 300 (MCS0 to MCS15)
  --802.11n (5GHz): 6.5 to 600 (MCS0 to MCS31)
  --802.11ac: 6.5 to 1,733 (MCS0 to MCS9, NSS = 1 to 4 for
  VHT20/40/80, NSS = 1 to 2 for VHT160)
  • 802.11n high-throughput (HT) support: HT 20/40
  • 802.11ac very high throughput (VHT) support:
  VHT 20/40/80/160
  • 802.11n/ac packet aggregation: A-MPDU, A-MSDU
  WI-FI ANTENNAS
  • AP-314/IAP-314: Four RP-SMA connectors for external
  dual band antennas. Worst-case internal loss between
  radio interface and external antenna connectors (due to
  diplexing circuitry): 0.6dB in 2.4 GHz and 1.2dB in 5 GHz.
  • AP-315/IAP-315: Four integrated dual-band downtilt
  omni-directional antennas for 4x4 MIMO with peak
  antenna gain of 3.6dBi in 2.4 GHz and 6.0dBi in 5 GHz.
  Built-in antennas are optimized for horizontal ceiling
  mounted orientation of the AP. The downtilt angle for
  maximum gain is roughly 30 degrees.
  --Combining the patterns of each of the antennas of the
  MIMO radios, the peak gain of the effective per-antenna
  pattern is 3.1dBi in 2.4 GHz and 3.8dBi in 5 GHz.
  OTHER INTERFACES
  • One 10/100/1000BASE-T Ethernet network interfaces (RJ-45)
  --Auto-sensing link speed and MDI/MDX
  --802.3az Energy Efficient Ethernet (EEE)
  • USB 2.0 host interface (Type A connector)
  • Bluetooth Low Energy (BLE) radio
  --Up to 4dBm transmit power (class 2) and -91dBm
  receive sensitivity
  --Integrated antenna with roughly 30 degrees downtilt
  and peak gain of 3.4dBi (AP-314/IAP-314) or 1.5dBi
  (AP-315/IAP-315)
  • Visual indicators (multi-color LEDs): For system and
  radio status
  • Reset button: Factory reset (during device power up)
  • Serial console interface (proprietary; optional adapter
  cable available)
  • Kensington security slot
  POWER SOURCES AND CONSUMPTION
  • The AP supports direct DC power and Power over
  Ethernet (POE)
  • When both power sources are available, DC power takes
  priority over POE
  • Power sources are sold separately
  • Direct DC source: 12Vdc nominal, +/- 5%
  --Interface accepts 2.1/5.5-mm center-positive circular
  plug with 9.5-mm length
  • Power over Ethernet (PoE): 48 Vdc (nominal)
  802.3af/802.3at compliant source
  --Unrestricted functionality with 802.3at PoE
  --When using IPM, the AP may enter power-save mode
  with reduced functionality when powered by an 802.3af
  PoE source (see details on Intelligent Power Monitoring
  elsewhere in this datasheet)
  --Without IPM, the USB port is disabled and transmit
  power of the 2.4 GHz radio chains are reduced by 3dB
  to 15dBm max when the AP is powered by an 802.3af
  PoE source
  • Maximum (worst-case) power consumption: 14.4W
  (802.3at PoE), 13.6W (802.3af PoE) or 12.7W (DC)
  --Excludes power consumed by external USB device (and
  internal overhead); this could add up to 6.4W (PoE) or
  5.9W (DC) for a 5W/1A USB device
  • Maximum (worst-case) power consumption in idle mode:
  6.4W (PoE) or 5.9W (DC)
  MOUNTING
  • The AP ships with two (black) mounting clips to attach to a
  9/16-inch or 15/16-inch flat T-bar drop-tile ceiling.
  • Several optional mount kits are available to attach the
  AP to a variety of surfaces; see the Ordering Information
  section for details.
  MECHANICAL
  • Dimensions/weight (unit, excluding mount accessories):
  --182mm (W) x 180mm (D) x 48mm (H)
  --650g/23oz
  • Dimensions/weight (shipping):
  --223mm (W) x 218mm (D) x 55mm (H)
  --850g/30oz
  ENVIRONMENTAL
  • Operating:
  --Temperature: 0° C to +50° C (+32° F to +122° F)
  --Humidity: 5% to 93% non-condensing
  • Storage and transportation:
  --Temperature: -40° C to +70° C (-40° F to +158° F)
  REGULATORY
  • FCC/ISED
  • CE Marked
  • RED Directive 2014/53/EU
  • EMC Directive 2014/30/EU
  • Low Voltage Directive 2014/35/EU
  • UL/IEC/EN 60950
  • EN 60601-1-1 and EN 60601-1-2
  • EN 50155 (AP-315/IAP-315)
  For more country-specific regulatory information and
  approvals, please see your Aruba representative.
  RELIABILITY
  MTBF: 916,373 hrs (105yrs) at +25C operating temperature
  REGULATORY MODEL NUMBERS
  • AP-314 and IAP-314: APIN0314
  • AP-315 and IAP-315: APIN0315
  CERTIFICATIONS
  • CB Scheme Safety, cTUVus
  • UL2043 plenum rating
  • Wi-Fi Alliance (WFA) certified 802.11a/b/g/n/ac
  • WPA, WPA2 and WPA3 – Enterprise with CNSA option,
  Personal (SAE), Enhanced Open (OWE)
  • Passpoint® (Release 2) with ArubaOS and Instant 8.3+
  WARRANTY
  • Aruba limited lifetime warranty
  MINIMUM OPERATING SYSTEM
  SOFTWARE VERSIONS
  • ArubaOS 6.5.0.0, 8.0.1.0
  • Aruba InstantOS 4.3.0.0

• RF PERFORMANCE TABLE
  	Maximum transmit power (dBm) per transmit chain	Receiver sensitivity (dBm) per receive chain
  802.11b 2.4 GHz
  1Mbps	18.0	-95.0
  11Mbps	18.0	-88.0
  802.11g 2.4 GHz
  6Mbps	18.0	-91.0
  54Mbps	16.0	-74.0
  802.11n HT20 2.4 GHz
  MCS0/8	18.0	-90.0
  MCS/7/15	14.0	-71.0
  802.11n HT40 2.4 GHz
  MCS0/8	18.0	-87.0
  MCS7/15	14.0	-68.0
  802.11a 5 GHz
  6Mbps	18.0	-90.0
  54Mbps	16.0	-73.0
  802.11n HT20 5 GHz
  MCS0/8/16/24	18.0	-91.0
  MCS7/15/23/31	14.0	-71.0
  802.11n HT40 5 GHz
  MCS0/8/16/24	18.0	-87.0
  MCS7/15/23/31	14.0	-68.0
  802.11AC VHT20 5 GHz
  MCS0	18.0	-90.0
  MCS8	12.0	-65.0
  802.11AC VHT40 5 GHz
  MCS0	18.0	-87.0
  MCS9	12.0	-62.0
  802.11AC VHT80 5 GHz
  MCS0	18.0	-83.0
  MCS9	12.0	-59.0
  802.11AC VHT160 5 GHz
  MCS0	18.0	-82.0
  MCS9	12.0	-57.0

• 

• FAQ

• Q1.What can you buy from us?

        A:Mellanox, Aruba, Rukus, Extreme brand products, including switches, network cards, cables, Access Point, etc.

  Q2.How about the delivery date?

        A:It usually takes 3-5 working days. For specific models, please contact us to check the stock. In the end, the actual                 consultation shall prevail. We will do our best to deliver as soon as possible.

  Q3.What's your warranty terms?

        A: We supply 12 months warranty time.

  Q4.How about the Shipping Method?

        A: We use Fedex/DHL/UPS/TNT and other air shipments,sea shipments are also workable. In one words, we could do any shipments that you wanted.

  Q5.Can I get some samples?

       A:Yes, sample order is available for quality check and market test. You only need to pay the sample cost and express cost.

  Q6.What are your core strengths?

       A:First-hand supply, Original and new products with the favorable price and perfect after-sales service.