HDPE Marine Pedestal 380V Dock Water Pedestal For Yacht Wharf

Product Specification

Marina Pedestal Aluminum Alloy Power Pedestal 380V Water Power Pedestal

Yacht marina can be divided into the aluminum alloy, steel structure marina, barge marina, combined marina. A barge dock. Not many people may have heard of a barge, but a barge is a rectangular, flat-bottomed boat that has no power and is not sailing. As the barge matures, the barge pier has two materials to choose from: concrete structure or rigid structure. It can be used as a temporary docking point or for permanent use.

In fact, marinas have gone through the age of plastic, concrete, and steel structures. Today, aluminum alloy marina should become mainstream, this kind of new material of yacht wharf, compared to the traditional yacht dock in the past, very obvious advantages, it's anti-corrosion ability is very good, very convenient in transportation and installation, to bear ability is very high, this kind of material of the yacht dock can use for a long time, is enduring, If the buoyancy tank and the panel are aging due to a long time of use, then it is only necessary to carry out a replacement of the parts of this part.

Introduction to Yacht Marina

1. Yacht marina: it is mainly composed of the embankment, fixed slope, movable ladder, main channel floating wharf, branch channel floating wharf, positioning pile, water supply, and power supply system, ships, upper and lower water ramp, lifting device, etc.

2, embankment: reinforced concrete pouring, stone masonry or other structural construction, mobile ladder connection embedded steel structure hinge device.

3, steel structure ladder: the main beam structure using hot rolled channel steel, handrails with square steel pipe or pipe connection, increase the load, the ladder surface laid anticorrosive board. The movable ladder and the embankment are connected by hinges, and the movable ladder and the floating dock are contacted by movable pulleys. The bearing area of the pulley is laid with steel plates to strengthen the steel structure framework of the floating dock and increase the bearing area.

4. Main (branch) floating dock: mainly composed of three parts/buoyancy box (buoyancy part), stressed steel structure (link and load main body), walkway (wooden frame and wood floor).

5. Positioning piles: there are mainly precast concrete pipe piles, steel piles, cast-in-place piles, wooden piles, etc.

6, water supply, power supply system: water supply with PP plastic pipe; Soft connection, power supply using Marine cable, special waterproof plug.

7. Engineering arrangement: preliminary scheme design, construction drawing design, signing of processing contract -- pontoon processing, accessories procurement -- civil construction (slope, piling) -- pontoon installation -- commissioning -- acceptance -- completion.

Charging pile waterproof type, simple structure, reasonable design, can achieve the yacht outdoor charging, doubts by setting the air hole and lower porosity, and out of the heat inside the watertight charging pile, the height of the porosity on the higher than the height of the bottom hole, prevent waterproof charging pile into the water, improve the service life of the waterproof type charging pile, by setting the rain cover plate to prevent charging pile body under the rain, By setting the socket protection device, on the one hand, it can play a protective role in the socket, on the other hand, it can prevent children from getting electric shock. By setting the dustproof filter net on the upper vent and the lower vent, it can prevent the dust from entering the waterproof charging pile, and improve the service life. By setting the spring buckle and the card slot inlaid, it is convenient to fix.