30Ton 50Ton Fully Automatic Waste Oil Distillation To Diesel Oil Plant With

Product Specification

Fully Automatic Waste Oil Distillation To Diesel Oil Plant With Solvent Refining Unit

The Latest technology 5-30T waste oil distillation machine to diesel is amazing technical solution for different
waste oil such as waste engine oil, pyrolysis oil, sludge oil, mud oil ,very thick dirty impurities oil. This technology is mainly to use

steam generator to make steam which can have effection with oil gas to reduce pressure to vacuum level.then when the operation is going

on, diesel can be produced at 300℃ -550℃,however,now the highest temperature is 300℃ -380℃.in this way oil quality will be highly

improved and also fuel can be used less.

This machine will need one-time catalyst which is produced by our company only, there is no need to buy from other catalyst factory as we have the catalyst formula .it is customized.

The pyrolysis oil with black color after distillation and remove color and smell , we will get synthetic diesel oil with yellow color,which can be used for diesel engines like trucks , tractors , ships etc.

Working process of waste engine oil distillation machine

Negative pressure distillation process
1),Waste engine oil Pre-processing
Settling tank. Put waste engine oil into the settling tank, separate the water first,then go through the 200 mesh filter to remove those

impurities such as solid and suspended solid.
2),High temperature flocculation to neutralize the tops
Reboiler. Pump the waste oil that have been pro-processed into the reboiler,in the condition of vacuum catalyzing and heat-exchanging to

raise the temperature to 310℃ to 320 ℃
3),Distillation by using vacuum film evaporator
After the temperature raised to 310℃ to 320 ℃ through reboiler,the oil will be absorbed into the first level taber type film evaporator

(vacuum degree -0.096--0.098MPa),and can generate a flash vaporization distillation process,gasifying to distill the light oil

components,the first level oil come out.
Those pre-processed oil that can not be flash gasified distillation,will be equably distributed to the upper of vacuum evaporation surface

in the effort of the evaporator distributor.Then goes to the second level taper type vacuum film evaporator.When the temperature of

evaporation surface reach 375 ℃--385℃,vacuum degree(-0.096--0.098),the second level flash evaporation gasifying process begins.By

gasifying and distilling the light base oil components,the second level oil come out.
The other oil that failed to be gasified and distilled will go into the third level taper type vacuum film evaporator.When the temperature

of evaporation surface reach 430 ℃--450℃,vacuum degree(-0.096--0.098),the third level flash evaporation gasifying process begins.By

gasifying and distilling the heavy base oil components,the third level oil come out.
Those heavy residue oil(asphaltene,colloid) that by no means cannot be gasified and distilled,in the end will produce a little waste

materials(1%-3%) into the receiver tank,then be discharged.
4),Refining (Distillation sites)
The first level oil ,second level oil,third level oil that come out through the vacuum film evaporator,will go through the rotating wire

mesh demister/skimmer(on top of the evaporator),to remove and purify the heavy residue oil foam drops.Those more purifier oil goes into

the distillation tower to divide;According to the amount ,the receiver oil goes into the high temperature vacuum clay adsorption to

refine.
The after refining base oil will go into their own storage tank after filtering and cooling down(temperature 50℃--60℃)

Technical Advantage

The equipment adopts advanced vacuum distillation technology, only need to add a small amount of additive materials which is low cost and

easy to buy.
The operation cost of the equipment is low, and the high quality base oil can be produced with very little cost.
The equipment is easy to operate, only 2 workers can operate.
It can process waste oil, waste motor oil, all kinds of waste engine oil and other mineral lubricating oil.
Its recovery rate is above 85%.
With high vacuum system, to ensure the equipment under the working vacuum operation.

We have got ISO9001 and ISO14001 Certifications. And also our products are equipped with CE Certification that

we have the rights to export our waste oil recycling machine to European. We also have got SGS certificate for

our pyrolysis oil products you can check the oil quality features from the analysis and chose the right market for

the end products.
we use one 40'FR container to load the reactor, and use the 40'HQ containers to load the cooling device, dedust

device and some small parts. The reacor is about 9200m *33400mm*31700mm. It is doable to take 40FR. It is over

width and over height. And Our integrity cooling device is designed to meet 40HQ size and it is easy to ship and

move the site place.

After-sales service

1.Engineers with over ten years’ waste to oil recycling experience will be dispatched to your place to provide technical service in guiding plant installation, plant commissioning as well as worker training.

2.We all know that good plant design and quality are essential, and good installation and training service are as important as or even more important than good plant design and quality. It is very dangerous if clients can not install or run the plant properly.

3.So, after plant installation finishes, our engineers are required to help you run the plant for at least 15 batches, enabling your workers to master all the operating skills needed and then operate the plant on their own.

FAQ of waste engine oil distillation machine

Q: Are there any bad smell or odor from waste tyre oil distillation equipment while distillation system is working?

A: There will be no smell at all as the gas produced by waste oil distillation plant will be purified by our exclusive tail gas purification unit before emission.

Q: What is the yield of this waste tyre oil distillation equipment?

A: Typically the yield of our waste oil distillation plant is between 85-90% (depending on variations of water content, light HC and others ingredients from waste oil.)

Q: How many areas are required to build the waste tyre oil distillation equipment?

A: The land area required usually depends on the capacity of your plant. We can calculate the area needed and give you the plant designs.

Q: What is the warranty of the waste tyre oil distillation equipment?

A: 12 months free guanantee and life long standard paid service.

Q: Can you install the production line and train our stuffs?

A: Yes we can. We'll send engineers to help you install the waste oil distillation plant and train your workers until the machine is skillfully operated.

Successful Case