1800rpm Oilfield Drilling Mud Cleaner Second Stage Separation Equipment

Product Specification

Second Stage Separation Equipment Oilfield Drilling Mud Cleaner

Mud cleaner is the second or third stage separation equipment for drilling fluids, that deals with the mud being treated by the first stage separation equipment shale shaker.

Mud cleaner Hunter 120 is designed to handle a high flow rate of fluid through the hydrocyclones which separate out fine solids into a concentrated underflow that is then distributed onto the vibratory screening deck. This combination of hydrocyclones and screening energy allow for treatment of a much higher flow rate of fluid than a vibratory screening unit can handle itself. This small compact unit is a powerful tool in removing small solids from a high flow rate stream while producing relatively dry solids that report off of the screening unit.  

Hunter 120 drilling mud cleaner

Drilling Mud Cleaners for Drilling Fluids Solids Control

This model Mud Cleaner combines 10” desander hydrocyclone(s) with smaller 4” hydrocyclones, effectively taking two “cuts” at the unwanted solids contaminating the fluid. The 10” remove large solids down to approximately 100 microns and the 4” can remove solids down to the 20 micron size range. The vibratory screening unit is designed to take the underflow of both size sets of hydrocylones and separate the concentrated solids from the liquid. The Mud Cleaner requires two pumps to operate, with the pump feeding the 10” cyclones typically taking a suction from a compartment upstream from the compartment from which the other pump takes its suction to feed the 4” hydrocyclones. The Mud Cleaner will be designed to handle the entire circulating volume of whichever system in which it is operating. Mud Cleaners are effective on both weighted and un-weighted drilling-fluid systems in removing and drying solids while retaining the expensive liquid phase. Used correctly, the Mud Cleaner can lower

How does drilling mud cleaner work?

Drilling mud is transferred to cones by a centrifugal pump from the shaker tank. Desander cone and desilter cone are fed by different pumps. This will provide better results. Under pump pressure, the fluids will run into cones and flow with centrifugal force. Then the heavy particles will deposit down and pushed out of cone drop in Apex.

After the mud cleaner processing, the solids larger than 15 microns will be separated out of drilling fluids. The drilling mud with solids sprays out of cones drop down to the bottom screen panel. Under vibration and filtration, the solids will be drier and save many fluids for a good drilling. The cleaned mud is transferred to centrifuge.

Spare parts of drilling mud cleaner

To know the mud cleaner parts well, we need to understand cleaner construction and main parts. Such as the desander cone, desilter cone, the bottom shaker, pipelines, pressure gauge. For the cones, there are hydrocyclone, coupling, drop in Apex, seal rubber, and so on

The bottom shaker, it is same as common shale shaker. Including the shaker basket, the shaker screen, the spring, the side rubber, channel protector, vibrator motor, the starter, and so on

Why select AIPU mud cleaner

AIPU is professional manufacturer on complete line solids control equipment. All wearing parts are high quality and universality assured. For the cones, all of them are made of high quality polyurethane. Fit with the Victaulic coupling.

Furthermore, AIPU is able to provide the interchangeable mud cleaner spare parts for other makes cleaner. The shaker screen produced by AIPU is API RP13C compliant. Our products and spare parts are highly appreciated by many clients

AIPU solids control always hold popular spare parts in stock for instant delivery. Cater for clients urgency, we promise 48 hours delivery to avoid any operation delay. We consider clients’ urgency so we get the preference so long time

For more information, please don't hesitate to contact AIPU solids control. You will get an optimal solution on mud conditioner or any other demand.