TP3057WM Electronic IC Chips Enhanced Serial Interface CODEC

Product Specification

TP3054, TP3057

‘‘Enhanced’’ Serial Interface CODEC/Filter COMBOÉ Family

General Description

The TP3054, TP3057 family consists of m-law and A-law monolithic PCM CODEC/filters utilizing the A/D and D/A conversion architecture shown inFigure 1, and a serial PCM interface. The devices are fabricated using National’s advanced double-poly CMOS process (microCMOS).

The encode portion of each device consists of an input gain adjust amplifier, an active RC pre-filter which eliminates very high frequency noise prior to entering a switched-capacitor band-pass filter that rejects signals below 200 Hz and above 3400 Hz. Also included are auto-zero circuitry and a companding coder which samples the filtered signal and encodes it in the companded m-law or A-law PCM format.

The decode portion of each device consists of an expanding decoder, which reconstructs the analog signal from the companded m-law or A-law code, a low-pass filter which corrects for the sin x/x response of the decoder output and rejects signals above 3400 Hz followed by a single-ended power amplifier capable of driving low impedance loads.

The devices require two 1.536 MHz, 1.544 MHz or 2.048 MHz transmit and receive master clocks, which may be asynchronous; transmit and receive bit clocks, which may vary from 64 kHz to 2.048 MHz; and transmit and receive frame sync pulses. The timing of the frame sync pulses and PCM data is compatible with both industry standard formats.

Features

• Complete CODEC and filtering system (COMBO) including:
  • Transmit high-pass and low-pass filtering
  • Receive low-pass filter with sin x/x correction
  • Active RC noise filters
  • m-law or A-law compatible COder and DECoder
  • Internal precision voltage reference
  • Serial I/O interface
  • Internal auto-zero circuitry
• m-law, 16-pin----TP3054
• A-law, 16-pin----TP3057
• Designed for D3/D4 and CCITT applications
• ±5V operation
• Low operating power----typically 50 mW
• Power-down standby mode----typically 3 mW
• Automatic power-down
• TTL or CMOS compatible digital interfaces
• Maximizes line interface card circuit density
• Dual-In-Line or surface mount packages
• See also AN-370, ‘‘Techniques for Designing with CODEC/Filter COMBO Circuits’’

Absolute Maximum Ratings

If Military/Aerospace specified devices are required, please contact the National Semiconductor Sales Office/Distributors for availability and specifications.

V_CC to GNDA                                                                                            7V

V_BB to GNDA                                                                                            -7V

Voltage at any Analog Input or Output                      V_CC +0.3V to V_BB -0.3V

Voltage at any Digital Input or Output                    V_CC +0.3V to GNDA -0.3V

Operating Temperature Range                                              -25℃ to +125℃

Storage Temperature Range                                                  -65℃ to +150℃

Lead Temperature (Soldering, 10 seconds)                                           300℃

ESD (Human Body Model)                                                                     2000V

Latch-Up Immunity ---- 100 mA on any Pin

Connection Diagrams

Block Diagram

Stock Offer (Hot Sell)