1.00mm Incision Depth Heel Blood Sampler Sterile Infant Safety Lancet

Product Specification

Heel Blood Sampler Product Dimension Table

Product structure And Composition

The heel blood collector consists of shells, springs, blades and elastic. The housing and elastomers are made of an acrylonitrile-butadiene-styrene (ABS) material. The spring is made of carbon spring steel wire; the blade is stainless steel.

Product Performance

• The appearance of the heel blood collector shall be clean without obvious burrs, stains and defects; the leaves shall be free from burrs and bending hooks.
• The heel blood collector is well assembled, with no significant dislocation of the casing.
• The surface hardness of the blade shall not be less than 350HV10; The blade surface roughness Ra value is not greater than 0.4 μM
• The corrosion resistance of the heel blood collector blade shall be Grade B (with corrosion marks).
• The heel blood collector blade can be retracted with the blade in the housing.
• The sterilization method is irradiation sterilization, and the product should be sterile
• The heel blood collector blade shall be of no therogen reaction.

Specifications And Dimensions

Usage Method

1. lets the baby lie on his back, clean the blood collection parts with disinfected cotton pieces, and dry naturally. Do not touch the disinfected parts.
2. Remove the outer packaging of the blood collector. Do not place the blood collector in unsterilized areas. Remove the safety buckle of the blood collector. No
Do not touch the blade when the start button is pressed.
3. carries the baby's feet to a position above the heart, and selects the safe blood collection position according to the "baby blood collection location schematic diagram", and the blood collection port is vertically aligned with the blood collection position.
4. When the flat end of the blood collection outlet has mild contact with the skin, press the start button to collect blood, and the blood collector quickly leaves the blood collection point.
5. gently wipes off the first drop of blood with a dry sterile gauze.
6.1 Press the appropriate pressure gently, and collect the appropriate amount of blood sample with the blood collection tube to collect blood. After the collection of blood, gently press the incision with dry sterile gauze to prevent the formation of hematoma.
6.2 Gently press the blood, directly sample the blood drops on the blood card, and collect at least three blood points continuously. After collecting blood, gently press the incision with dry sterile gauze to stop the bleeding to prevent the formation of hematoma.

Contraindication

1. should not be used for infants (including fever) unless absolutely necessary.
2. does not repeat collecting blood samples at the same location.
Do not use 3. puncture sites in infants with edema, infection, or inflammation.
4. is not used at puncture sites for infants with skin disease or skin damage.
5. avoids selecting skin within 2mm near the sampling point as the blood collection location.

Matters Needing Attention

1. The safety belt buckle of blood sampler is lost or broken, so please do not use it.
2. The blood sampler is disposable, so please replace it with a new one every time you take blood.
3. The safe area for infant blood collection is between the line parallel to the side of the foot drawn from the middle of the fourth and fifth toes and the line parallel to the side of the foot drawn from the big toe.
4. When the blood collection site is disinfected, the disinfection diameter should be greater than 2cm.
5. Underdevelopment of blood vessels may lead to insufficient blood flow.
6. If you need to preheat your heel, 42℃-44℃ will help promote blood circulation, but over 44℃ will cause burns.
7. The blood sampler should be close to the blood collection site and inserted into the needle vertically, but should not use too much force to avoid causing deep and harmful wound depth.
8. When using the blood sampler, always be vigilant to avoid accidental injury to yourself and others.
9. After blood collection, pay attention to the blood collection place to prevent bleeding or inflammation again.
10. The blood sampler is sterilized by irradiation, and the validity period is 3 years. Over the period of validity, is strictly prohibited.
11. Blood sampler may be contagious after use, and shall not be discarded at will to prevent pollution and injury.

Keep In Storage

It shall be stored in a cool, dry, well ventilated and clean environment with relative humidity not more than 80% and temperature not more than 45 ℃, without corrosive gas

Company profile

Zhongxiu Science And Technology Co.,Ltd., is a high-tech enterprise engaged in the research and development, production and operation of in vitro diagnostic products. The in vitro diagnostic products developed by the company cover POCT series, microbial series, biochemical series and immune series reagents and supporting instruments.
The company has always adhered to the core concept of "fast and accurate, living up to life", committed to providing society with excellent products and services, and contributing to the cause of human health.